Magma ROBEN Series User Manual page 37

Install Thermal Pad
Go to page 60 for instructions on how to install Thermal pad.
Connect Cable
1. Connect the thunderbolt cable to thunderbolt port on the back of the unit.
2. Connect the other end of the Thunderbolt cable to Mac mini thunderbolt port.
Plug-in Power Cord
Connect the power cord to the power receptacle on the back of the unit. The Mac mini does not have a Rocker
On/Off switch on the back of the unit.
Powering on and powering off the unit
Roben-3 will automatically turns ON when the computer is turned ON. A White light located on the front panel will
shine when the expansion chassis is ON.
Roben-3 will automatically turn OFF when the computer is turned OFF or goes into Standby mode.
C. Two green LEDs on the Interface card are illuminated.
D. No LEDs are illuminated on the backplane.
Verify Connection
1. You should see four (or Five) Green LEDs illuminated on the interface card and three on the backplane. For
more information on LEDs go to pages 18 to 25.
Roben 3 | Chapter 2 Hardware Installation
Magma
37