Pcie Expansion Interface Card Installation; Pcie Host Interface Card Installation - Magma Roben-3TX User Manual

PCIe Expansion Interface Card Installation

By default the Expansion Interface card SW1 switch is set to "ON=EXP." The expansion system will NOT
function if SW1 is set to OFF=HOST.
1. Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable
from Expansion chassis or from computer
2. Unscrew the Expansion Interface
3. Install new Expansion Interface card
4. Plug-in the card in PCIE slot#0. This is the designated slot for the interface card. Installing the
Interface card in a non-designated slot will cause the system to not operate

PCIe Host Interface card Installation

Begin the installation of your PCI Express (PCIe) host card by first powering down your computer.
The PCIe host card is a "half-height," x8-capable PCIe card mounted to a "full-height" bracket as shown
below.
For low profile case applications, you may need to change the mounting bracket to the low profile bracket
that shipped with your system. This is done by removing the screws that hold the card to the bracket. Be
sure
you are using proper ESD procedures when completing this action.
Roben 3 | Chapter 5 Converting to PCIe
Magma
57