Magma ROBEN Series User Manual page 22

Magma
LEDs D6 and D8 are illuminated when power cord is attached to expansion unit. This means the expansion unit is
on standby-mode. The magma device is" switched off" on the electronic interface (but it draws some power). On
standby mode the Magma is not performing its primary function; it is waiting to be activated by a remote power or
remote controller. See picture below.
FIGURE T2-C
D6
D8
If the above LEDs are not coming ON, please check the power standby cable make sure it is firmly connected to
Thunderbolt Interface card power connector (J7). See page 25.
Thunderbolt™ 2 Interface Card LEDs: Standby-Mode
Roben 3 | Chapter 2 Hardware Installation 22