Magma ROBEN Series User Manual page 52

1. Connect the SAS / SATA Cable to the controller card. Depending on how many drives you have installed. If
you have four drives installed you have to connect one SAS / SATA Cable to controller card. Make sure all
four drives are in one bay location. The storage bays are divided into two, four drives per bay.
2. Plug-in controller card in any available PCIe slots and secure it.
3. See Chapter for Hardware and Software Configuration
Install Expansion Interface card
The Expansion Interface card is already installed for this model. No need to install the Expansion Interface card. If
you need to replace or install an Expansion Interface card, go to Expansion Interface card Installation on page
44.
Roben 3 | Chapter 2 Hardware Installation
Magma
52