Table of Contents
Advertisement
Protecting Against Electrostatic Discharge
Electrostatic Discharge (ESD) Warning
Electrostatic Discharge (ESD) is the enemy of semiconductor devices. You should always take
precautions to eliminate any electrostatic charge from your body and clothing before touching any
semiconductor device or card by using an electrostatic wrist strap and/or rubber mat.
Static electricity can harm system boards. Perform service at an ESD workstation and follow proper ESD procedures
to reduce the risk of damage to components. Magma strongly encourages you to follow proper ESD procedures,
which can include wrist straps and smocks, when servicing equipment.
You can also take the following steps to prevent damage from electrostatic discharge (ESD):
•
When unpacking a static-sensitive component from its shipping carton, do not remove the component's anti-
static packaging material until you are ready to install the component in a computer. Just before
unwrapping the anti-static packaging, be sure you are at an ESD workstation or are grounded.
•
When transporting a sensitive component, first place it in an anti-static container or packaging.
•
Handle all sensitive components at an ESD workstation. If possible, use anti-static floor pads and workbench
pads.
•
Handle components and boards with care. Don't touch the components or contacts on a board. Hold a
board by its edges or by its metal mounting bracket.
Roben 3 | Preface
Magma
6
Advertisement
Table of Contents
