Thunderbolt Interface Card Installation - Magma ROBEN Series User Manual

Thunderbolt Interface Card Installation

The following steps are applicable on how to replace and install a Thunderbolt Interface card.
1. Turn off the Expansion chassis first. Disconnect the power cord. Disconnect the Thunderbolt cable from
Expansion chassis or from computer.
2. Unplug the Interface power cable from Thunderbolt Interface card. Unscrew to remove the interface card.
3. Plug-in the Thunderbolt Interface card in PCIE slot#0. This is the designated slot for the interface card.
Installing the Interface card in a non-designated slot will cause the system to malfunction.
4. Plug-in the power cable Thunderbolt Interface card. Secure the interface card.
IMPORTANT
The Roben 3 expansion unit will not power up if the Interface power cable is not attached to
Thunderbolt Interface card or if it is disconnected from the backplane.
Roben 3 | Chapter 2 Hardware Installation
Magma
26