Connect Thunderbolt Cable; Powering On And Off The Expansion Unit - Magma ROBEN Series User Manual

Magma

Connect Thunderbolt Cable

Attach Thunderbolt cable into either top or bottom port on the Roben-3. Plug in Display Monitor, DVI/HDMI, or
Display. If no display will be used, you can daisy chain other Thunderbolt devices. Plug in the other end of the
Thunderbolt cable to the Thunderbolt port on the computer.
Connect the Thunderbolt cable to one of the ports on the back of Roben 3 and connect the other end of the cable to
the Thunderbolt port on the computer. You can use the available Thunderbolt port for attaching a Thunderbolt
device or an external display monitor.

Powering On and Off the Expansion Unit

Roben-3 will automatically turns ON when the computer is turned ON. A White light located on the front panel will
shine when the expansion chassis is ON. Roben-3 will automatically turn OFF when the computer is turned OFF or
goes into Standby mode. If either end of the Thunderbolt cable is removed while the system is ON, the expansion
chassis will automatically power down.
The White light on the front of Roben-3 is not an ON (On-off push button), it simply indicates whether the chassis is
on or off. If either end of the Thunderbolt cable is disconnected, Roben-3 will automatically turn off.
Roben 3 | Chapter 2 Hardware Installation 17