Table of Contents
Advertisement
Magma
Troubleshooting
Q: If the Thunderbolt card fails to power up, what should I check?
A: Check the power / stand-by cable; make sure it is firmly connected to the power receptacle of the Thunderbolt
Interface card.
Q: How do I know if Roben-3power supply is working?
A: If the Thunderbolt card is properly seated and connected, there should be 4 green LEDs lit on the Interface
card, 3 green LEDs lit on the backplane, and 1 green LINK LED is turned ON as shown below. This picture below
applies to Thunderbolt™ 1 expansion unit.
Roben 3 | Chapter 3
Verify Installation
88
Advertisement
Table of Contents
