Table of Contents
Advertisement
2.
Turn power switch to ON position.
3.
Thunderbolt expansion unit goes into stand-by mode when the power supply is turned ON. Two green LEDs
on the Interface card are illuminated. No LEDs are illuminated on the backplane.
Thunderbolt Card Installation
Roben-3T (Thunderbolt 3 Slot PCIe expansion) + 8 Drive Bays comes with Thunderbolt Interface card installed. If
you need to install a Thunderbolt Interface card go to Thunderbolt Interface Card Installation on page 26 for
instructions.
Thunderbolt Cable Installation
1.
Connect the thunderbolt cable to thunderbolt port on the back of the unit.
Roben 3 | Chapter 2
Hardware Installation
Magma
33
Advertisement
Table of Contents
