Securing the Top Cover
It is best to secure the top cover with the three thumb screws on the back of the unit when carrying, transporting or
shipping the expansion unit. If required, additional retention of the cover may be achieved using the four mounting
holes under the enclosure.
NOTE: All Roben 3 models come with the 4 mounting screws (enclosed in a small plastic bag) for the option of
securing the bottom part of the cover to the chassis.
1.
Turn over the expansion chassis to expose the bottom part where the mounting holes are located as shown for
the pictures below.
2.
Install the screws to their designated mounting holes to secure the bottom part of the cover as shown from the
pictures below.
Roben 3 | Chapter 2
Hardware Installation
Magma
59