Connecting To The Target Board; Figure 15. Connecting The Host Pc, Usb Debug Adapter And Target Board - Holtek HT32 Series Quick Start Manual

32-bit ARM ® Cortex TM -M3 MCU
HT32 Series
6

Connecting to The Target Board

The target board can be powered via the USB port or a 5V DC adaptor by changing the on-board
jumpers. Refer to the corresponding target board documentation for details.
The e-Link32 USB debug adapter, that is connected to the target board SWD interface via the
ARM 2.54mm pitch 10-pin connector, helps to download and debug the embedded software onto
®
the target hardware.
The following figure shows the host PC, USB debug adapter and target board connection.

Figure 15. Connecting the host PC, USB debug adapter and target board

Rev. 1.00 14/35 �01��0����