Figure 23. Debug Configurations Dialog - Open Configuration Page; Figure 24. Debug Configurations Dialog - Select Debug Adapter - Holtek HT32 Series Quick Start Manual

32-bit ARM ® Cortex TM -M3 MCU
HT32 Series
3. Click "{PROJECT NAME}.configuration" in the left side of the Debug Configuration dialog to
open the configuration page.
Figure 23. Debug Configurations Dialog – Open Configuration Page
4. Select e-Link32 as the adapter in the Debugger tab. If "Run to main()" is checked, the application
will first be run to "main()" in "Debug mode".
Figure 24. Debug Configurations Dialog – Select Debug Adapter
Rev. 1.00 �0/35 �01��0����