32-bit ARM
®
Cortex
TM
-M3 MCU
HT32 Series
Using Breakpoint
1. Double click on the line to set a breakpoint before the program starts running. A red point will
then appear in front of the line.
Figure 39. Add a breakpoint
2. Click the "Run" icon to start the program. Since the breakpoint has been previously set, the
program will stop immediately at the first breakpoint (which is nearest to the program counter).
The yellow arrow indicates the current location that will be executed.
Figure 40. Stop at breakpoint
Rev. 1.00
30/35
�01��0����