Hydraulic Brake Unit: Removal - Refitting - Renault Duster 2007 Manual

ANTI-LOCK BRAKING SYSTEM

Hydraulic brake unit: Removal - Refitting

ANTI-LOCK BRAKING SYSTEM
Equipment required
pedal press
Tightening torquesm
hydraulic brake unit
bolts on the support
rigid brake pipe unions
on the hydraulic brake
unit
hydraulic brake unit
earth wire nut
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions and opera-
tion recommendations before carrying out any
repair:
- (see 38C, Anti-lock braking system, ABS: Pre-
cautions for the repair, page 38C-4) ,
- (see ) (01D, Mechanical introduction).
WARNING
Prepare for the flow of fluid, and protect the sur-
rounding components.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Position the pedal press on the brake pedal to limit
the outflow of brake fluid.
a Remove the soundproofing clips from the bulkhead.
a Move the soundproofing away from the bulkhead to
access the hydraulic brake unit.
II - REMOVAL OPERATION
8 N.m
13 N.m
8 N.m
a Remove:
- the hydraulic brake unit earth wire nut (1) ,
- the hydraulic brake unit earth wire (2) .
a Unclip the earth wire from the hydraulic brake unit at
(3) .
a Disconnect the hydraulic brake unit connector (4) .
a Unscrew the rigid pipe unions (5) from the hydraulic
brake unit.
a Fit blanking plugs on the openings of the hydraulic
unit and brake pipes.
38C-5
38C
145076
145074