Renault Duster 2007 Manual page 929

Rotary switch: Removal - Refitting
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Set the wheels straight ahead.
a Lock the airbag computer (see Fault finding - Re-
placement of components) (88C, Airbags and pre-
tensioners).
a Disconnect the battery (see 80A, Battery, Battery:
Removal - Refitting, page 80A-2) .
a Remove the steering column switch assembly (see
84A, Control - Signals, Steering column switch
assembly: Removal - Refitting, page 84A-2) .
II - OPERATION FOR REMOVAL OF PART
CONCERNED
a Remove:
- the bolts (1) from the wiper stalk,
- the bolts (2) from the lighting stalk.
CONTROL - SIGNALS
108743
84A-1
REFITTING
I - REFITTING PREPARATION OPERATION
a Check that the rotary switch tape is correctly centred
(2.5 rotations on each side).
Note:
If the rotary switch is being replaced, the new
part is supplied ready centred with an adhesive
label which will tear off when the wheel is turned
for the first time (wheels must be straight when
fitting).
a Ensure that the wheels are set straight ahead.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the bolts to the lighting stalk,
- the bolts to the wiper stalk.
III - FINAL OPERATION
a Refit the steering column switch assembly (see 84A,
Control - Signals, Steering column switch as-
sembly: Removal - Refitting, page 84A-2) .
a Connect the battery (see 80A, Battery, Battery: Re-
moval - Refitting, page 80A-2) .
a Unlock the airbag computer (see Fault finding - Re-
placement of components) (88C, Airbag and pre-
tensioners).
IV - CHECKING AFTER REPAIR
a Switch on the ignition.
a Check the operation of the rotary switch:
- turn the steering wheel to the left until it stops,
- turn the steering wheel to the right until it stops,
- bring the steering wheel back to the central posi-
tion,
- check that there are no faults on the instrument
panel.
84A