Renault Duster 2007 Manual page 318

Coolant pump: Removal - Refitting
K4M
REFITTING
I - REFITTING PREPARATION OPERATION
a
IMPORTANT
Wear leaktight gloves (Nitrile type) for this opera-
tion.
IMPORTANT
Wear goggles with side protectors for this opera-
tion.
WARNING
Do not scrape the joint faces of the aluminium,
any damage caused to the joint face will result in
a risk of leaks.
a Use SUPER CLEANING AGENT FOR JOINT FA-
CES (see Vehicle: Parts and consumables for
the repair) (04B, Consumables - Products) to clean:
- the coolant pump sealing face if it is to be reused,
- the cylinder block gasket face.
a Apply the product to the surfaces to be cleaned.
a Leave for approximately ten minutes.
a Remove the residue using a wooden spatula.
a Complete the cleaning of the parts using an abrasive
pad.
WARNING
T o ensure proper sealing, the gasket surfaces
must be clean, dry and not greasy (avoid any fin-
ger marks).
a Use SURFACE CLEANER (see Vehicle: Parts
and consumables for the repair) (04B, Consum-
ables - Products) to degrease the joint faces.
COOLING
a
a Apply at (2) a bead of RESIN ADHESIVE (see Ve-
hicle: Parts and consumables for the repair)
(04B, Consumables - Products) 0.6 to 1 mm wide.
19A-17
WARNING
Applying excess sealant could cause it to be
squeezed out when parts are tightened. A mix-
ture of sealant and fluid could damage certain
components (engine, radiator, etc.).
19A
10063