Renault Duster 2007 Manual page 782

Visual inspection of the sealing:
(Only for watertight connectors)
• Check for the seal on the connection (between the 2 parts of the connection).
• Check the seal at the back of the connectors:
– For unit joints (1 for each wire), check that the unit joints are present on each electrical wire and that they
are correctly positioned in the opening (level with the housing). Check that plugs are present on openings
which are not used.
– For a grommet seal (one seal which covers the entire internal surface of the connector), check that the
seal is present.
– For gel seals, check for gel in all of the sockets without removing the excess or any protruding sections
(it does not matter if there is gel on the contacts).
– For hotmelt sealing (heat-shrink sheath with glue), check that the sheath has contracted correctly on the
rear of the connectors and electrical wires, and that the hardened glue comes out of the side of the wire.
• Check that there is no damage to any of the seals (cuts, burns, significant deformation, etc.).
If a fault is detected, repair or replace the wiring (see Technical Note 6015A, Electrical wiring repair, Wiring:
Precautions for repair)
MR-453-X79-62C000$010.mif
V1
CLIMATE CONTROL
Fault finding – Introduction
62C-7
62C