Renault Duster 2007 Manual page 107

TOP AND FRONT OF ENGINE
Accessories belt: Removal - Refitting
K9K, and AIR CONDITIONING
Tightening torquesm
tensioning roller bolt
WARNING
Do not run the engine without the accessories belt
to avoid damaging the crankshaft accessories pul-
ley.
WARNING
In order to avoid any refrigerant leaks, do not dam-
age (deform, twist, etc.) the pipe.
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
- the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front right-hand wheel arch side liner,
- the front right-hand wheel arch liner partially (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
- the plastic shield underneath the diesel filter.
II - REMOVAL OPERATION
40 N.m
a Rotate the accessories belt auto tensioner clockwise
using a 16 mm offset wrench.
a Remove:
- the accessories belt,
- the accessories belt tension wheel.
REFITTING
I - REPAIR PREPARATION OPERATION
a parts always to be replaced: Accessories belt.
a parts always to be replaced: Accessories belt
tensioning roller
a parts always to be replaced: Accessories ten-
sioning roller bolt
WARNING
Only use brushes with plastic or non-corrosive
metal (brass) bristles.
a To remove all deposits, use a brush to clean the
grooves of:
- the crankshaft pulley,
- the air conditioning compressor pulley,
- the alternator pulley,
a Refit a new tensioning roller fitted with a new bolt.
a Tighten to torque the tensioning roller bolt (40
N.m).
11A-4
11A
101878