Renault Duster 2007 Manual page 451

a
WARNING
T o avoid weakening the pipe, either bend once or
bend progressively by increasing the bend (that
is, by continually decreasing the curve radius).
Do not install a rigid pipe on a vehicle that may
have been bended and then unbended alterna-
tively to reach the correct curve radius.
Note:
During the bending operation, the required angle
should be passed slightly in order to compensate
for material elasticity.
a Shape the pipe using a bender, curve after curve,
while respecting the original shape of the pipe.
GENERAL INFORMATION
Rigid brake pipe: Repair
30A-10
30A
128814