Setting The Ldap Server - Printronix LP654C User Manual

5
Select [Enable] in [Wireless(Infrastructure)] of [Basic Settings].
The factory default setting is "Disable".
6
Select [Manually set the connection to access point ] in [Wireless Network Selection].
7
Select [Next].
8
Input the SSID name of the Wireless(AP Mode) network to connect in [SSID].
9
Select [WPA/WPA2-EAP] in [Security] of [Security Settings].
10
After all the basic settings and security settings are configured, click the [Submit] button on the
lower left corner of the web screen to apply the settings. It may take about 1 minute to connect
to the Wireless(AP Mode) network. If the connection fails, reset the wireless settings from the
operator panel, or switch to wired LAN from the operator panel and reset the wireless settings
from the web page.

Setting the LDAP server

 Consult your network administrator for the LDAP server and encryption setup.
1
Open the web page of this machine.
Opening the web page
2
Log in as an administrator.
Logging in as an administrator
3
Select [Admin Setup].
4
Select [Network] - [LDAP Server Setting].
5
Input the FQDN or IP address of the LDAP server in [LDAP Server].
When selecting [Digest-MD5] or [Secure Protocol] for [Method] in Step 9, input the FQDN instead of the IP
address. An FQDN is a combination of the host name and domain name. (Example of FQDN:
Server1.domain.local)
6
Input the port number of the LDAP server in [Port Number].
7
In [Timeout], specify the timeout value to wait for the search result.
8
Specify the BaseDN to access the LDAP server in [Search Root].
- 218 -