Using The Access Control Function (Ip Filter) With The Ip Address - Printronix LP654C User Manual

5
Configure the settings following the on-screen instructions.
For the "Phase 2 Proposal" setting, [AH] or [ESP] must be enabled.
[AH] and [ESP] cannot be used simultaneously. When both [AH] and [ESP] are enabled, only [ESP] is used.
6
Click [Submit].
The new settings will take effect after the network function of the machine has been reset.
 If IPSec cannot be set up due to the inconsistency of specified parameters, the web page cannot be accessed. In this
case, disable IPSec or initialize network settings from the operator panel of this machine.
Go to "
Setting up your PC
Setting up your PC
It is necessary to set IPSec on your PC. For the setting method on the PC, please consult your network
administrator.

Using the access control function (IP filter) with the IP address

You can use the IP Address to control the access to this machine. You can set whether to authorize setup or
printing from the specified IP address. IP filtering is disabled by default.
 Be sure to specify the correct IP address. If you specify an incorrect IP Address, you will not be able to access the
machine using the IP protocol.
 When IP filtering is enabled, any access to the host not specified in this setting will be denied.
1
Open the web page of this machine.
Opening the web page
2
Log in as an administrator.
Logging in as an administrator
3
Select [Admin Setup].
4
Select [Network] - [Security] - [IP Filtering].
5
Configure the settings following the on-screen instructions.
If nothing is registered in [Administrator's IP Address setting], access to this machine may be disabled
depending on the specified IP address range.
If you are using a proxy server, [Your Current Local Host/Proxy IP Address] may not match the IP address of
the current host.
6
Click [Submit].
The new settings will take effect after the network function of the machine has been reset.
 IP filtering is applicable only to IPv4.
".
- 212 -