Printronix LP654C User Manual page 111

Item
HU Setting
VL Cleaning
Gloss Mode
Drum Cleaning (Fn236)
High Humid Mode
Office Document Mode
Moisture Control
Factory
default
settings
Off Sets the mode to remove the dirt due to
leaving this machine idle for a long period of
time.
Execute Improves the printing result when there are
white streaks in the vertical direction.
Off A mode used to print with an increased
fixing temperature and improved gloss.
Please select [On] when you want to print
more glossy.
Off Sets to empty the drum before printing when
white streaks appear in the horizontal
direction. When it is turned on, the
remaining service life of the image drum will
be shortened.
Off The paper may curl when the paper is
ejected at a high humidity. Set this setting to
[Mode1] or [Mode2] to reduce the curling
effect.
Try [Mode2] if [Mode1] does not reduce the
paper curling effect.
The printing time is longer than the case of
[Off].
When [Mode1] or [Mode2] is set, the service
life of the image drum will be shortened.
Mode1 In the case of Mode 1, toner is saved
according to the setting of [Admin Setup] -
[Print Setup] - [Toner Save] - [Toner Save
Level].
In the case of Mode 2, if [Toner Save Level]
is set to [Off], toner is saved by 5%. When
[Toner Save Level] is set to [Low], [Middle]
or [High], toner is saved according to the
settings.
Off Enables/Disables the moisture control.
When [Mode1] or [Mode2] is set, it is
possible to prevent the paper from
absorbing moisture at high humidity and
prevent the paper from getting wet. It may
take much time to print the first page.
- 112 -
Description