Replacing The Belt Unit - Printronix LP654C User Manual

Replacing the belt unit

For the replacement cycle, see "
1
Pull the front cover open lever (blue) to open the front cover.
2
Pull the L2 lever and lift the output tray to the stop position.
3
Remove the belt unit by holding its blue handle.
Do not touch the fuser unit because it is hot.
Because image drums (green parts) can easily get damaged, handle with adequate care.
Do not expose the image drum to direct sunlight or strong light (About 1,500 lux or above). Do not leave it
uncovered for more than 5 minutes even under room lighting.
4
Take the new belt unit out of its box.
".
Belt unit
Doing so may cause burns.
- 308 -