Removing The Workstation Access Panel - Compaq Professional Workstation AP200 Reference Manual

Removing the Workstation Access
Panel
1. Turn off the workstation and any external devices.
2. Disconnect the power cord from the grounded AC outlet, the network
cable from the system, then disconnect any external devices.
3. Remove the two screws that secure the access panel to the workstation
chassis.
4. Slide the access panel back about 1 inch (2.5 cm), then lift it off the unit.
Figure 4-1. Removing the workstation access panel
To replace the access panel, reverse the above steps.
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
CAUTION: Before removing the workstation access panel,
ensure that the workstation is turned off and that the power cord
is disconnected from the grounded AC outlet.
File Name: E-CH04.DOC Last Saved On: 1/19/99 9:40 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP200 Reference Guide
4-5