Compaq Professional Workstation AP200 Reference Manual page 146

E-6 Error Codes
Power-On Self Test Message
Message
601-Diskette Controller
Error
602-Diskette Boot
Record Error
605-Diskette Drive
Type Error
610-External Storage
Drive Failure
611-Primary Floppy
Port Address
Assignment Conflict
612-Secondary Floppy
Port Address
Assignment Conflict
912-The Computer
Cover Has Been
Removed Since Last
System Start Up.
* L = Long, S = Short
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
Continued
Beeps* Probable Cause
None Diskette controller circuitry or
floppy drive circuitry incorrect
None Diskette in drive A not bootable. Replace the diskette.
2S Mismatch in drive type
None External tape drive not
connected
2S Configuration error
2S Configuration error
None
File Name: L-APPE.DOC Last Saved On: 12/14/98 2:40 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Recommended Action
1. Run Setup.
2. Check and/or
replace cables.
3. Replace diskette
drive.
4. Replace the system
board.
Run Computer Setup or
Windows NT utilities.
Reinstall tape drive or
press F1 and allow
system to reconfigure
without the drive.
Run Computer Setup or
Windows NT utilities.
Run Computer Setup or
Windows NT utilities.
Continued