Compaq Professional Workstation AP200 Reference Manual page 30

2-8 Software
Computer Setup
Set resources for onboard system devices
(serial port, parallel port, and so forth)
View the currently installed PCI devices and
their IRQ settings and/or and reconfigure IRQ
settings for these devices or disable them
entirely
NOTE: This option will not appear if there
are non PnP devices currently installed.
View the current settings of Plug and Play
(PnP) devices and set resources for installed
boards
Enable/disable PCI bus mastering, PCI reset
on warm boot, and PCI VGA palette snooping
Set ISA back-to-back I/O (fast/legacy) delay
and bus priority (ISA/PCI)
Set the printer mode (flexible/standard)
Set the Num Lock state at power-on
Specify which VGA controller is the primary
(or boot) VGA controller
NOTE: This selection appears only if there
are multiple PCI graphics controllers in your
system.
Save the system configuration to a blank
1.44 MB diskette
Restore the system configuration from a
diskette
Restore factory default settings and exit
Computer Setup
Exit Computer Setup without applying or
saving any changes
Save changes to the system configuration
and exit Computer Setup
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
Continued
Task
File Name: C-CH02.DOC Last Saved On: 12/15/98 4:21 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Computer Setup Selection
Select Advanced, then select Onboard
Devices.
Select Advanced, then select PCI
Devices.
Select Advanced, then select ISA PnP
Devices.
Select Advanced, then select Bus
Options .
Select Advanced, then select Bus
Options .
Select Advanced, then select Device
Options.
Select Advanced, then select Device
Options.
Select Advanced, then select PCI VGA
Configuration.
Select File, then select Save to Floppy.
Select File, then select Restore from
Floppy.
Select File, then select Set Defaults and
Exit.
Select File, then select Ignore Changes
and Exit.
Select File, then select Save Changes
and Exit.