Compaq Professional Workstation AP200 Reference Manual page 27

Using Computer Setup
To access the Computer Setup utilities menu:
1. Turn on or restart the workstation. If you are in Windows, click Start,
then Shut Down. Restart the workstation.
2. When the F10 Setup message appears in the lower-right corner of the
screen, press the F10 key.
NOTE: If you do not press the F10 key while the message is displayed, you
must turn the workstation off, then on again, to access the utility. The F12 key
initiates Network Service Boot for Remote System installation. See Chapter 3
of this guide for more information about this feature.
The Computer Setup menu appears with the following menu headings: File,
Storage, Security, Power, and Advanced. See Table 2-1 for a description of the
features available in Computer Setup.
3. Press the arrow keys or the Tab key to select the option you want, then
press the Enter key. To return to the main menu, press the Esc key.
4. To apply and save changes, select File, then Save Changes and Exit. If
you selected an option that automatically restarted the workstation,
changes were applied at that time. If you have made changes that you do
not want applied, select Ignore Changes and Exit. If you have already
applied changes you now want to eliminate, select Set Defaults and Exit.
This option will restore the original system defaults.
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments: 352620-003
File Name: C-CH02.DOC Last Saved On: 12/15/98 4:21 PM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Compaq Professional Workstation AP200 Reference Guide
2-5