Removing The Side Access Panel - Compaq SP700 Reference Manual

6-4 Hardware Upgrade Preparations

Removing the Side Access Panel

To remove the side access panel:
1. Turn off the workstation and disconnect the power cord from the
2. Refer to the following illustration to remove the side access panel.
Figure 6-1.
grounded AC outlet and the back of the workstation.
Loosening the four rear panel thumbscrews and removing
the side access panel
IMPORTANT: When replacing the side access panel, be sure to tighten all
four thumbscrews.
NOTE: The hood labels attached to the inside of the side access panel provide
system configurations and the installation of additional components.