Cold Start Aid; Fuel Filter System - New Holland LS140 Workshop Manual

COLD START AID

The EIC controls a timed preheat cold start aid to
assist in cold weather starting.
STARTING A COLD ENGINE
Move the engine speed control ahead to 1/3 position,
maximum 1500 RPM.
Turn the ignition key, 1, to the "RUN" position. The
EIC will automatically activate the engine preheat
system and the preheat light, 2, will be on, also at this
time the character display, 3, will read the seconds
remaining to heat. When the light goes off and the
display is 0, turn the ignition key to the "START"
position. After the engine starts, allow the key to
return to the "RUN" position.
The engine must start within 30 seconds; if the
engine does not start preheat again. Allow the starter
to cool for one minute before engaging the starter
motor. To start the preheat sequence again, turn the
ignition key off and then on again.
Always allow the engine to operate at a maximum of
1500 RPM to warm up before applying a load.

FUEL FILTER SYSTEM

The unit is equipped with a fuel filter water trap, 1.
Drain the water trap filter every 100 hours of
operation, or sooner if water is found in the fuel
supply. To drain the water trap, turn the drain cock, 2,
on the bottom of the cartridge and allow the water to
drain. Replace the filter every 500 hours.
Replace the in-line filter, 1, every 250 hours of
operation. To remove the filter, remove the two hose
clamps, 2, and remove the hoses from the filter.
Install a new filter, hoses, clamps and tighten.
WARNING
All service should be performed with the engine
shut down. If servicing the skid steer with the
boom in the raised position, be sure the boom
arms are supported by the boom lock pins.
SECTION 10 - ENGINE
1
2
19992563
10-89
Copyright © New Holland
145
146
147