Eic Lock Mode - New Holland LS140 Workshop Manual

1
2

EIC LOCK MODE

A two digit code can be entered into the EIC which will
lock the boom and bucket spool lock solenoids when
the spools are in the neutral position. This will prevent
movement of the boom and bucket.
The same two digit code must be reentered to unlock
the solenoids and return the skid steer to normal
operation.
To enter a security code:
1. Lower the boom and bucket to the ground and
position the bucket to prevent movement of the
skid steer.
2. Turn "OFF" the ignition key.
3. Unbuckle the seat belt, raise your weight off the
seat, and wait until all EIC lights are off.
4. While out of the seat, press and hold the "OPEN
BOOK" switch, 2, then sit in the seat and turn the
ignition key to the "ON" position; Do Not engage
the starter.
5. Display, 3, will show the program level of the EIC
board (example r0100). At this time release the
"OPEN BOOK" switch.
6. Display, 3, will show "LOC_ _" for lock.
7. Press and hold the "OPEN BOOK" switch until
two (2) zeros appear "LOC 0 0" with the left zero
flashing, then release the "OPEN BOOK" switch.
8. Press and release the "OPEN BOOK" switch and
enter any number from "0" - "9" for the left digit.
9. Press and release the "ARROW" switch, 1, the
right zero will start to flash.
10. Press and release the "OPEN BOOK" switch and
enter any number from "1" - "9" for the right digit.
SECTION 55 - ELECTRICAL SYSTEM
11. With the two (2) digit code entered, "01 - 99", turn
To reenter the same two (2) digit code to return
the skid steer to normal operation:
1. Sit in the operator's seat.
2. The EIC will display "LOC 0 0" with the left digit
3. Turn the ignition key switch to the "ON" position;
4. Press and release the "OPEN BOOK" switch and
5. Press and release the "ARROW" switch, the right
6. Press and release the "OPEN BOOK" switch to
7. Turn the ignition key to the "OFF" position and
8. Buckle the seat belt and proceed with normal
If the two digit code is forgotten, the EIC can be
unlocked by using a (MASTER CODE). Contact your
NEW HOLLAND dealer for assistance.
The dealer will require your name, address and the
skid steer model and serial numbers.
55-31
3
the ignition key to the "OFF" position and exit the
skid steer, allowing all the EIC board lights to go
"OFF", locking the EIC.
When the EIC board lights go off, the lock code
will enter the EIC memory, locking the EIC until
the same two digit code is reentered.
flashing.
Do Not engage the starter.
enter the left number of the code previously used
to lock the skid steer.
zero will flash.
enter the right number of the code previously
used to lock the skid steer.
allow the EIC to return to the operating mode.
skid steer operation.
Copyright © New Holland
22