Charge Check Valve - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

CHARGE CHECK VALVE

Op. 29 100 36

REMOVAL AND REPLACEMENT

1. Lower the boom and bucket to the lowered posi-

tion, resting on the ground, or remove any attach-

ment and raise the boom and rest on the boom

lock pins, 1.

Never work under a raised boom unless it is

properly supported by the boom lock pins.

Never work under a raised boom with an attach-

ment. Always remove the attachment from the

2. Stop the engine, turn the ignition key to the run

position and operate the boom and bucket con-

trol pedals to relieve pressure in the boom and

bucket circuits. Turn off the key.

3. Put the Service/Run switch, 1, in the "SERVICE"

4. Engage the parking brake.

5. Securely block the skid-steer loader with all four

wheels off the ground. Refer to Section 1 for

more information on properly supporting a skid-

steer loader.

Failure to securely support the skid-steer loader

could result in movement of the loader causing

serious injury or damage to the equipment.

SECTION 29 - HYDROSTATIC TRANSMISSION

Table of Contents