New Holland LS140 Workshop Manual page 542

13. Route the wire harness to the front of the cab to
the ignition switch and EIC board area. Attach the
wires to the ignition switch and position the wire
harness to prevent damage. Reinstall the switch
panel, 1.
14. Attach the wire harness connectors to the proper
EIC board connector, 2, and position the wire
harness across the front of the dash area, 3, to
prevent damage. Reinstall the EIC board.
15. Reinstall the EIC making sure the wire harness
clears the EIC board and the EIC board does not
contact the dash frame area, 1. Tighten the
switch retaining hardware, 2, and EIC board
hardware, 3.
16. Reinstall wire harness shield behind seat at 1,
with retaining hardware, 2.
17. Reconnect the negative (–) battery cable.
18. Check the electrical system for proper operation.
19. Reinstall all shields and fender removed for
harness installation.
SECTION 55 - ELECTRICAL SYSTEM
55-117
3
2
3
1
Copyright © New Holland
1
165
166
167