Back-Up Alarm - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

BACK-UP ALARM

The back-up alarm serves as an audible warning de-

vice to alert bystanders and other machine operators

of machine movements. The alarm will only sound

when both hydrostatic control levers are stroked into

reverse. Refer to local codes for requirements.

IMPORTANT: Before servicing any switches or

alarm, disconnect the negative (–) battery ground

cable to avoid accidental shorts in the wiring system

when removing or installing components.

Alarm Location

The back-up alarm sound device should be located

to the inside and in the upper right rear corner of the

engine rear door at 1.

With the battery connected, and both hydrostatic

control levers in the neutral position, loosen and slide

both strikers, 1, rearward until the alarm sounds.

Move the strikers forward until the alarm stops

(approximately 1.5 mm [1/16"]) and tighten the hard-

Back-up Alarm Wiring

The alarm is a negative (–) ground system.

SECTION 88 - ACCESSORIES

Table of Contents