Troubleshooting - New Holland LS140 Workshop Manual

TROUBLESHOOTING

FINAL DRIVE SYSTEM
Before servicing or adjusting the final drive system,
the skid-steer loader should be jacked up with the
wheels off the ground.
Remove any attachment from the skid-steer loader
boom, bucket, etc. Lower the boom to the lowered
position or, if servicing requires the boom to be in the
raised position, support the boom on the boom locks.
Raise the boom and lower onto boom lock pins, 1.
1. Raise boom above boom lock pins.
2. Engage boom lock pins.
3. Stop engine, ignition key "OFF" position.
4. Turn ignition key to the "ON" position.
5. Lower boom onto boom lock pins.
6. Turn the ignition key to the "OFF" position.
CAUTION
Never exit the loader with the boom in the raised
position unless the boom is supported on the
boom lock pins.
Never work under a raised boom unless it is
properly supported by the boom lock pins.
Never work under a raised boom with an attach-
ment mounted. Always remove the attachment
from the loader.
Jack up the loader and support the loader with the
wheels off the ground, using adequate jack stands or
blocks to securely support the loader.
Support the loader at the front of the final drive cases
at 1, and at the rear at 2.
CAUTION
Never service a raised loader unless it is securely
supported with adequate jack stands or blocks.
SECTION 44 - AXLES AND WHEELS
44-5
Copyright © New Holland
5
6