Timing Gear Case Installation - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

Check rotor tip clearance to specification.

Clearance Specification

0.01 - 0.15 mm

(0.0004" - 0.006")

TIMING GEAR CASE INSTALLATION

NOTE: NEVER TURN THE CRANKSHAFT until the

timing gear cover is installed.

Rotate the oil pump cover to position the locating hole

in the twelve o'clock position. Start the timing cover

on the mounting studs.

Connect the start (excess fuel) spring.

Insert the governor link through the hole in the

cylinder block toward the fuel injection pump.

Rotate the oil pump cover to align the locating hole

with the spring pin in the timing gear cover and slide

the cover into position.

NOTE: Do not damage the oil seal when passing it

over the crankshaft. Rotate the mechanical stop

lever clockwise to aid in assembly.

SECTION 10 - ENGINE

Allowable Limit

Table of Contents