Spill Timing Procedure - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

Installation Using a New Pump or Drive

Procedure when infection pump, engine block,

camshaft gear, camshaft, idler gear or

crankshaft have been replaced.

NOTE: The engine stop solenoid must be removed

before installing the pump.

1. Position the injection pump in the block using a

new shim gasket, 1, of 0.5 mm (0.012")

Connect the governor link to the pump control

rack and secure with the spring clip.

NOTE: Check the control rack for any binding

condition by moving the pump control rack back and

2. Install the pump mounting bolts and tighten to 9

-12 N⋅m (7 - 9 ft. lbs.).

SPILL TIMING PROCEDURE

1. Remove the No. 1 delivery valve holder, 3,

(nearest the radiator), the spring, 2, and delivery

valve piston and stem assembly, 1.

NOTE: The delivery valve assembly consists of a

piston and stem assembly operating within a guide

body. Do not remove the guide body for spill timing.

Serious pump damage will result!

2. Reinstall the delivery valve holder and spring.

Tighten the holder finger tight.

SECTION 10 - ENGINE

Table of Contents