New Holland LS140 Workshop Manual page 615

Hide thumbs Also See for LS140:

Table of Contents

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)

7. Using a cutting torch, cut the weld around the hub

to separate the hub from the main boom. DO

NOT cut any material from the main boom. Grind

to remove any remaining weld and hub from the

8. Position the hubs on the boom straight, from side

to side, with center spacing, 2, as follows, and

tack weld the hubs to the boom.

Hub Center Spacing - 626 mm (24.65")

9. Reinstall the mounting plate and tapered pivot

pins and hardware. Pivot the mounting plate up

and down to ensure there is no binding between

the mounting plate and pivot pins. Weld the hubs

to the boom.

10. Install the hub reinforcement gussets described

earlier in these instructions.

11. Lubricate the pivots and torque and hammer seat

the tapered pins and hardware. Refer to "Attach-

ment Mounting Plate" repair in this section.

Chapters

Table of Contents