Neutral Adjustment - New Holland LS140 Workshop Manual

Hide thumbs Also See for LS140:

Table of Contents

Op 29 130 06

NEUTRAL ADJUSTMENT

Before making any adjustments, make sure there is

no binding in the control linkage, shocks, or neutraliz-

er plate. The neutralizer plate, 1, should be free to

move on the spring retaining bolt at the engine bell-

housing and on the front slides. The neutralizer plate

should be against the stop on the engine bellhousing

The loader must be raised and supported with the

tires off the ground. Use adequate blocking or jack

stands to securely support the loader.

The engine must be started and running to make

neutral adjustments. Place the Service/Run Switch,

1, in the "SERVICE" position to allow the engine to be

To adjust the left side, loosen the block retaining

bolts, 1, slightly and move the control arm, 2, to stop

wheel rotation. Now move the block so it contacts

both cams on arm, 2, and tighten the retaining bolts,

To adjust the right side, loosen the block retaining

bolts, 3, slightly and move the control arm, 4, to stop

wheel rotation. Now move the block so it contacts the

cams on arm, 4, and tighten the retaining bolts, 3.

Stop the engine after adjustments are made and re-

check hardware torque.

NOTE: The blocks must be set square and firmly

contact both cams on the arms. If the block is not

square against both cams on the arms, the unit may

creep after neutral adjustments are made.

SECTION 29 - HYDROSTATIC TRANSMISSION

Table of Contents