9. Move the boom control to the "DETENT" (float)
position and turn the ignition key to the "OFF"
position.
10. Use a pry bar and align cylinder with boom and
install pivot pin, 1, and retaining hardware, 2, and
⋅
torque to 38 N
m (28 ft. lbs.).
MAJOR UNIT OVERHAUL
For a major hydrostatic component or engine repair,
the skid steer cab and boom assembly can be tilted
forward for easier access to the components area.
Figure 16 shows the skid steer properly supported
and the cab tilted forward.
WARNING
Never attempt to tilt the skid steer cab without
using the proper tool and instructions. See more
detail later in this section of the manual and/or
contact your New Holland dealer.
SECTION 00 - GENERAL INFORMATION
00-18
Copyright © New Holland
16