Copyright © New Holland
SECTION 10 - ENGINE
ENGINE REASSEMBLY SEQUENCE
PRECAUTIONS
Thoroughly wash parts before reassembly. Ensure
oil galleys are clean and unobstructed.
Lubricate all rotating and sliding components before
assembly.
Clean all gasket surfaces, using care not to scratch
mating surfaces. Use special care on aluminum
parts. Discard and replace all removed gaskets. Use
liquid gasket where necessary.
Never over-tighten threaded fasteners used on
aluminum parts. Tighten only to specified torque
values.
OIL PRESSURE RELIEF VALVE ASSEMBLY
Install a new O ring on the relief valve assembly, 1.
Install the relief valve into the block. Tighten to 58 -
68 N⋅m (43 - 50 ft. lbs.)
99
10-63