New Holland LS140 Workshop Manual page 628

SECTION 82 - FRONT LOADER (BOOM AND MOUNTING PLATE)
Loader faceplate, 5, and attachment, 6, engage-
ment.
3. Check the saddle area of the attachment at 1, for
interference, weld, debris, etc. to prevent the at-
taching plate and attachment from seating prop-
erly.
4. The loader latch pin should engage the lower
latch plates as shown at 2.
5. Check for clearance between the faceplate and
attachment at 3, minimum 0.8 mm (1/32") and
maximum 9.5 mm (3/8"), with the latch pins fully
engaged.
a. If there is no clearance at 3, the loader face-
plate is too short or the distance between the
top saddle area and lower latch plates is too
great, 2, Figure 87.
b. If the clearance is too great or the latch pins
will not engage into the latch plates on the at-
tachment, the loader faceplate is too long or
the distance between the top saddle area
and lower latch plates is too short, 2, Figure
87 or the latch plates are located incorrectly,
1, Figure 87.
6. When the latch pins are fully engaged, New Hol-
land buckets only, the end of the pin should not
extend beyond the lower plate at 4.
a. If the latch handles do not fully engage, the
dimension from the back of the attachment to
the rear of the slot in the latch plates is too
short at 1, Figure 87.
b. If the latch pins extend below the lower plate
at 4, the dimension from the back of the at-
tachment to the rear of the slot in the latch
plate is too long at 1, Figure 87.
1
6
3
82-39
Copyright © New Holland
5
2
4
86