Installation - New Holland W190C Tier 4 Service Manual

2000-10

Installation

1
2
3
4
5
6
7
1. ENGINE MOUNT BOLT
2. WASHER
STEP 42
If engine r ubber isolators require replacement,
remove and discard isolators (3 and 4). Install new
rubber isolator (4), then rubber isolator (3).
STEP 43
Slowly raise engine and move into position over rear
chassis. Be sure all harness connections and hoses
are out of the way then lower engine. Put washer (5)
between front rubber isolator (4) and chassis. Install
washer (2), bolt (1), washer (6), and nut (7) in engine
isolators. Lower engine into position.
STEP 44
Tighten engine mounting bolts to a torque of 244 to
298 Nm (180 to 220 lb-ft).
STEP 45
Disconnect lifting equipment from engine lift ing
brackets.
STEP 46
Connect engine oil drain hose to frame bracket.
1
2
3
8
4
5
6
7
3. INSOLATOR UPPER
4. INSOLATOR LOWER
5. WASHER
6. WASHER
STEP 47
At front of engine, position drive shaft on engine
coupling. Install six bolts to secure dr ive shaft to
engine coupling. Tighten the six bolts to a torque of
53 to 62 Nm (39 to 46 lb-ft). For W190C machines
equipped with 5-Speed transmissions, tighten bolts
to a torque of 86 to 126 Nm (63 to 93 lb-ft).
NOTE: The bolts that fasten the engine drive shaft to
the engine must be replaced when removed.
1
2
3
4
5
6
7
7. NUT
8. REMOTE OIL DRAIN HOSE
BS03B035
BD03A172