4-6.11 Set Supervisor / User Password - SOLTEK K8AV2-R Manual

4-6.11 SET SUPERVISOR / USER PASSWORD

These two options allow you to set your system passwords. Normally,
the supervisor has a higher priority to change the CMOS setup option
than the users. The way to set up the passwords for both Supervisor
and Users are as follows:
1. Choose "Change Password" in the Main Menu and press <Enter>.
Then following message appears:
2. The first time you run this option, enter your password up to 8 char-
acters and press <Enter>. (The screen does not display the entered
characters.)
3. After you enter the password, the following message appears prompt-
ing you to confirm the password:
4. Enter the same password "exactly" the same as you have just typed
to confirm the password and press <Enter>.
5. Move the cursor to Save & Exit Setup to save the password.
6. If you need to delete the password entered before, choose the Su-
pervisor Password and press <Enter>. It will delete the password
that you have entered before.
7. Move the cursor to Save & Exit Setup to save the option you have
just configured; otherwise the old password will still be there the next
time you turn your system on.
8. Press <Enter> to exit to the Main Menu.
RxD , TxD Active The option controls the speed between receiving and
IR Transmission Delay When UART Mode is selected in IrDA or ASKIR
EPP Mode Select Select EPP Mode when you choose EPP or
"Enter Password :
"Confirm Password :
transmitting of IrDA or ASKIR when using.
Choices: Hi,Hi; Hi,Lo; Lo,Hi; Lo,Lo
mode, it allows you to enable / disable IR Transmis-
sion Delay.
ECP+EPP mode in the Parallel Port Mode.
Choices: EPP1.7; EPP1.9
81
Chapter 4 BIOS Setup
"
"