Memory Installation; 2-2.1 To Install Ddr Sdram Module; 2-2.2 To Remove A Dimm - SOLTEK K8AV2-R Manual

K8AV2-R / K8AV2-RL

2-2 Memory Installation

2-2.1 To Install DDR SDRAM Module

• This series supports up to 2GB DDR 400/333/266 SDRAM, with 2
DDR DIMM slots on board. Do not insert other type of modules into
these slots.
• DDR DIMM slot has 184-pins and one notch. Insert a DDR SDRAM
vertically into the 184-pin slot with the notch-to-rib matching.
• Make sure to unplug your power supply before adding or removing
memory module. Failure to do so may cause severe damage to both
your mainboard and the memory module.
• Pay attention to the orientation of the DIMM slots. Forcing a DIMM
into a slot improperly will damage the memory module and slot itself.
184-Pin DIMM Notch Key Definitions
DRAM Key Position
(2.5V Voltage Key)

2-2.2 To Remove a DIMM

Power off system and press down the holding latches on both sides of
slot to release the module from the DIMM slot.
Voltage Key Position
DDR Notch
Module Latch
DDR Rib
18