Attaching The Header (M205 Windrowers) - MacDon R85 Operator's Manual

6. Set the forming shield side deflectors to the desired
width by repositioning adjuster bars (A). Use the same
hole location on both sides.
7. Adjust rear fluffer deflector (C) to middle position.
Loosen handles (B) if required.
8. Attach the R85 header to the windrower.
to the MacDon self-propelled windrower operator's
manual, and then return to this manual to complete
the attachment.
9. Connect the hydraulics and electrical harness. See
the following pages for instruction, specific to your
windrower model.

5.7.2 Attaching the Header (M205 Windrowers)

The R85 13-foot header requires motor/hose kit MD
#B5456 installed to enable operation on a M205 windrower.
If required, obtain the kit through your MacDon Dealer and
install it in accordance with the instructions supplied with
the kit.
DANGER
Stop engine and remove key from ignition before
leaving operator's seat for any reason. A child or
even a pet could engage an idling machine.
To attach the header to an M205 windrower, follow
these steps.
169455
OPERATION
Figure 5.24
Refer
Figure 5.25: MD #B5456
41
Rev. E