Attaching The Header (M205 Windrowers) - MacDon R85 Operator's Manual

7. Set the forming shield side deflectors to the desired
width by repositioning adjuster bars (A). Use the same
hole location on both sides.
8. Adjust rear fluffer deflector (C) to middle position.
Loosen handles (B) if required.
9. Attach the R85 header to the windrower. Refer to the
windrower operator's manual, and then return to this
manual to complete the attachment.
10. Connect the hydraulics and electrical harness. Refer
to the following pages for instruction, specific to your
windrower model.

5.7.2 Attaching the Header (M205 Windrowers)

DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
Refer to your windrower operator's manual for procedures to mechanically attach the header to the self-propelled
windrower. Refer to the following procedures for electrical and hydraulic connections:
169457
OPERATION
Figure 5.26: Forming Shield Adjuster Bar
43
Revision G