Attaching The Header: M205 Windrowers - MacDon R85 Operator's Manual

7. Set the forming shield side deflectors to the desired
width by repositioning adjuster bars (A). Use the same
hole location on both sides.
8. Adjust rear fluffer deflector (C) to middle position.
Loosen handles (B) if required.
9. Attach the R85 header to the windrower. Refer to the
windrower operator's manual, and then return to this
manual to complete the attachment.
10. Connect the hydraulics and electrical harness.
• For M205, refer to
M205 Windrowers, page
• For M200, refer to
M200 Windrowers, page

3.7.2 Attaching the Header: M205 Windrowers

DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
Refer to your windrower operator's manual for procedures to mechanically attach the header to the windrower. Refer
to the following procedures for electrical and hydraulic connections:
The R85 13-foot header
(MD #B5456) installed to enable operation on an M205
Self-Propelled Windrower.
If required, obtain the kit through your MacDon Dealer and
install it in accordance with the instructions supplied with
the kit.
147757
OPERATION
3.7.2 Attaching the Header:
39.
3.7.3 Attaching the Header:
44.
requires motor/hose
Figure 3.24: Forming Shield Adjuster Bar
kit
Figure 3.25: MD #B5456
39
Revision B