Replacing The Fuser Unit (3041/3042) - Epson AcuLaser CX37DN Series User Manual

Replacing the Fuser Unit (3041/3042)

When the time to replace the fuser unit is reached, the message Fuser Unit Life appears. Printing
can continue even after this message appears; however, since the print quality is reduced, the fuser unit
should be replaced immediately.
1. Turn off the printer and disconnect the power cord and interface cover.
Note:
There are extremely hot parts within the machine. Before replacing the fuser unit, wait about
40 minutes after turning off the machine, and then check that the fusing section has reached room
temperature, otherwise, you may get burnt.
2. Pull the lever, and then open the right door.
Note:
Before opening the right door, fold up Tray 1.
3. Holding the section with the green sticker (*) attached, open the fuser unit cover.
Epson AcuLaser CX37 Series
Replacing Consumables and Maintenance Parts
Printer/Copier/Scanner User's Guide
184