Specifying The Copy Quality Setting - Epson AcuLaser CX37DN Series User Manual

Note:
If the number of copies was incorrectly entered, press the Back key, and then specify the correct
number of copies.
5. To print color copies, press the Start (Color) key. To print monochrome copies, press the Start
(B&W) key.
Copying begins.
Note:
❏ If the Stop/Reset key is pressed while copying, JOB CANCEL appears. To stop copying, select YES.
To continue copying, select NO.
❏ If COLOR COPY in ADMIN. MANAGEMENT/PASSWORD SETTING/FULL FUNC. NO. has been
restricted, type in the number specified for FULL FUNC. NO. after pressing the Start key.

Specifying the Copy Quality Setting

Select the document type and copy density appropriate for the contents and density of the document
to be copied.
Selecting the Document Type
1. In the main screen (Copy mode), press the u or d key to select the current copy quality setting, and
then press the Select key.
2. Press the u or d key to select MODE, and then press the Select key.
3. Press the u or d key to select MIX, TEXT, PHOTO, FINE/MIX, FINE/TEXT or FINE/PHOTO, and
then press the Select key.
The main screen (Copy mode) appears again.
Note:
The default setting is FINE/MIX. However, when a document is loaded into the ADF, the setting MIX
is automatically selected in order to give priority to the speed.
The setting can be changed after a document is loaded into the ADF. Follow steps 1 through 3,
described above, to change the setting.
After a document loaded into the ADF is finished being copied, the default setting FINE/MIX is
automatically selected.
However, the setting that was changed before the document was loaded into the ADF is retained.
Epson AcuLaser CX37 Series Printer/Copier/Scanner User's Guide
Using the Copier 126