Epson AcuLaser CX37DN Series User Manual page 92

Duplexing
DO NOT use thick stock that is
❏ Mixed with any other media in the trays (as this will cause media misfeeding)
Envelope
Print on the front (address) side only. Some parts of the envelope consist of three layers of paper—the
front, back, and flap. Anything printed in these layered regions may be lost or faded.
You can print continuously with envelope. However, this could affect the media feed, depending on
the media quality and printing environment. If problems occur, stop the continuous printing and
print one sheet at a time.
Capacity
Orientation
Driver Media
Type
Duplexing
Use envelopes that are
❏ Common office envelopes approved for laser printing with diagonal joints, sharp folds and edges,
and ordinary gummed flaps
Note:
Because the envelopes pass through heated rollers, the gummed area on the flaps may seal. Using
envelopes with emulsion-based glue avoids this problem.
❏ Approved for laser printing
❏ Dry
DO NOT use envelopes that have
❏ Sticky flaps
❏ Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for sealing
Epson AcuLaser CX37 Series
Not supported with copy functions
Supported with printing functions
Up to 10 sheets, depending on their thickness
Tray 1
Tray 2/3 Not supported
Face down
Envelope
Not supported
Printer/Copier/Scanner User's Guide
Media Handling 92